- Category: Articles
- Published on Friday, 06 January 2012 14:51
- Written by Administrator
The Chain Sinnet is the first paracord item I have ever made about 20 years ago I was tough this by my brother when he was on leave from the army, You want to start with a simple loop and fallow the photos they will walk you all the way though!
The rule of thumb is to use a foot for every inch your wrist is and with the Chain sinnet you want to start in the middle of the length you cut, putting your half hitch in the middle and using the two cords making loops and putting one inside the other till your done, but depending on how you’re going to finish this bracelet you will want to put a clasp or leave a little loop for a button so when your finished you can wear it!
You can see at this point the Chain Sinnet forming and all there is to it is to continue till your finished.
Now you’re at the end you have checked the length and it fits your wrist, like I said earlier there is many ways to finish this type of bracelet but this is how I did mine, taking the two ends you want to leave one open loop and one sinched tight now I have put two skull beads on the ends and burned the ends of the paracord so they will not come off, next you want to put the loop you started with inside the one you ended with and using the bead end put it through the loop you put through jamming it making a clasp.
Now you can see the finished product and if you every have the need to use the paracord take the bead ends and with this bracelet all you do is pull and it will come apart in seconds and if you have any question as always feel free to email or post in our forum and we will get back to you ASAP!
One question I get asked all the time where can I get them little skulls? Well I have looked for many months online and I found only one good place, where they have a wide selection and very good prices and its where we get all ours at www.SkullsvilleUSA.com click this link to check them out!